Manual output calibration mode – allows to pair oscillator with popcorn and adjust each octave precisel
Connect CV OUT to the V/OCT input of your oscillator. Hold down button 1 and 4 at startup and you enter the manual calibration mode.
Rotate TRIG A / SLIDE TIME KNOB to select the octave – TRIG A and TRIG B leds indicate the selected octave (0-5V).
Select 0V (lowest octave-fully CCW), connect output of your oscillator to a chromatic tuner and fine tune its pitch precisely to correspond to the desired root note.
Select first octave by turning the TRIG A / SLIDE TIME KNOB.
Press buttons 2 and 3 to make fine increments UP and DOWN for voltage for the selected octave. Check the tuner for tuning precision.
Press buttons 1 and 4 to make larger increments UP and DOWN for the selected octave.
Repeat for the remaining octaves.
Press FN button to leave this mode and save the calibration table.