Skis - DIY
In the front of every ski there is a curve similar to a decay envelope. Skis module has two channels A and B and each of them consists of a decay envelope with knob control and a VCA.
There is a TRIGGER input to trigger the envelope, a buffered envelope output which is normalised to the CV input of the VCA. Than there is SIGNAL IN and OUT of the VCA. There is also a CRUNCH switch which activates a special mosfet lo-fi VCA circuit inspired by designs of Standa Filip. This adds a slight crunchy character which changes with the decay of the envelope. A typical application of Skis is to take two signals (noises for example) and generate drum sounds with adjustable DECAY from them with a TRIGGER signal. However, you can also use the two VCAs and two DECAY envelopes independently.
- dual decay envelope with adjustable decay time (trigger input, CV output)
- dual vca (signal IN, signal OUT, CV IN is normalized to CV output of decay envelope)
- crunch feature inspired by circuits of Standa Filip
- jumpers for changing the decay envelope to release envelope (vca is on full while there is a gate signal and than it decays)
- jumpers for enabling the decay knob to completely mute the decay envelope
- jumpers for selecting weird filtering of the output signal (also inspired by Standa Filip)
- front panel from oak wood, handmade custom knobs
- handmade in Brno, Czech republic
- 5 HP
- current: +12: <30mA, -12: <20mA
- 35mm deep (skiff friendly)
- PTC fuse and diode protected 10 pin power connector